β″－Al_2O_3陶瓷的强化和韧化

研究了稳定ＺｒＯ＿２和部份稳定ＺｒＯ＿２对β″－Ａｌ＿２Ｏ＿３陶瓷的强化和韧化作用，观察了不同种类、不同含量的ＺｒＯ＿２对β″－Ａｌ＿２Ｏ＿３陶瓷的显微结构、力学性能和电导率的影响，探讨了β″－Ａｌ＿２Ｏ＿３的韧化机理。     

Hydrodechlorination of 3-chloropyridine and chlorobenzene in methanol solution over alkali-modified zirconia-supported palladium catalysts

The liquid-phase hydrodechlorination of 3-chloropyridine and chlorobenzene has been studied over alkali-modified zirconia-supported palladium catalysts. The modification of the ZrO₂ with alkali metal carbonates improves the catalytic activity of the final palladium catalyst. Therefore, the larger the ionic radii (Li⁺ < Na⁺ < K⁺), the greater the catalytic activity (TOF) of the palladium catalyst. For 3-chloropyridine, hydrodechlorination proceeds without catalyst deactivation. This is explained as the result of the interaction of reaction products (pyridine and HCl) forming pyridinium chloride, thus avoiding the detrimental effect of HCl on the palladium particles. Catalytic hydrodechlorination of chlorobenzene over Pd catalysts exhibits an initial catalytic activity (TOF) much lower than that of 3-chloropyridine and the Pd catalysts deactivate as the reaction proceeds. Finally, chlorobenzene hydrodehalogenation has also been carried out in the presence of an equimolecular amount of pyridine resulting in a decrease in the initial reaction rate on the one hand, but also in an increase in final conversion on the other.     

钒钛渣对刚玉莫来石耐火材料的侵蚀研究

通过不同温度下钒钛渣对刚玉莫来石耐火材料的侵蚀实验，分析了炉渣、温度对材料的影响，认为致密结构、低气孔率是提高炉衬寿命的关键，板条状莫来石的存在利于减缓渣的侵蚀过程。     

Thermal Conductivity Measurement of an Electron-Beam Physical-Vapor-Deposition Coating

An industrial ceramic thermal-barrier coating designated PWA 266, processed by electron-beam physical-vapor deposition, was measured using a steady-state thermal conductivity technique. The thermal conductivity of the mass fraction 7 % yttria-stabilized zirconia coating was measured from 100 °C to 900 °C. Measurements on three thicknesses of coatings, 170 μm, 350 μm, and 510 μm resulted in thermal conductivity in the range from 1.5 W/(m·K) to 1.7 W/(m·K) with a combined relative standard uncertainty of 20 %. The thermal conductivity is not significantly dependent on temperature.     

Effect of Preparation Methods and Condition of Precursors on the Phase Composition of Yttria-Stabilized Zirconia Powders

An yttria-stabilized zirconia powder, free of monoclinic phase, may be prepared by an oxalate method in an ethanol solution at strong acidity. This study demonstrates that the control of pH in the preparation of precursors has a significant effect on the ability of precursors to crystallize and hence plays an important role in determining the formation and fraction of various crystalline phases in the resulting yttria-stabilized zirconia powder. With the increase of pH, a precursor with a certain crystalline form may be transformed into an amorphous precursor, and a monoclinic phase appers in the phase composition of the resulting powder. The results of XRD analysis and Raman spectroscopy are discussed.     

Crystallization of glass in fireclay refractories; part III: Detailed study on the mullite crystal size in the ‘synthetic’ glass

Poor-grade fireclay products contain substantial amount of glass. A glass of similar composition was synthesized, nucleated and heat-treated for crystallization of mullite. The size and size-distribution of mullite crystals, the rate of change of size and the aspect ratio of the crystals were investigated in relation to the nucleating agents and temperature.     

自韧Si3N4陶瓷的显微结构及其性能研究

利用热压的方法制得室温断裂韧性和抗弯强度分别为１１．２ＭＰａ·ｍ￣（１／２）、８２３ＭＰａ，高温（１３５０℃）断裂韧性和抗弯强度分别为２３．９ＭＰａ·ｍ￣（１／２）、６３０ＭＰａ的自韧Ｓｉ＿３Ｎ＿４陶瓷。研究了显微结构和力学性能之间的关系。结果表明：玻璃相的含量、β－Ｓｉ＿３Ｎ＿４的长径比等对性能有重要影响。分析了自韧Ｓｉ＿３Ｎ＿４陶瓷的增韧机理，通过ＳＥＭ明显观察到Ｓｉ＿３Ｎ＿４中存在裂纹偏转、分支和β－Ｓｉ＿３Ｎ＿４拔出现象。     

Technique for Producing Mullite and Other Mixed-Oxide Systems

Mixed-oxide systems are of interest in a variety of technical ceramic applications. The key in many systems is to achieve a high degree of homogeneity, approaching the molecular level. A technique for producing mixed oxides via direct oxidation of mixtures of organometallic compounds is discussed as a potential route. Preliminary work performed on producing mullite is discussed.     

稀土锆莫来石耐火材料的显微结构研究

本文运用ＸＲＤ、ＳＥＭ等方法对稀土锆莫来石耐火材料的显微结构，物相变化，以及稀土的作用机制进行了研究。     

合成彩色立方氧化锆的宝石学特征

市场上出现的紫色、浅紫色、浅黄色、粉红色、酒黄色、黄褐色、红色人造立方氧化锆均为亚金刚光泽, 火彩明显; 密度为5.99～6.34 g/cm3, 相对硬度为8～9; 除粉红色者表现出非均质性和弱多色性且内含大量定向排列的白色脱溶物外, 其余的为均质性, 内部洁净; 不同颜色的立方氧化锆的吸收光谱、紫外荧光以及滤色镜下的变色情况均存在差异; 浅紫色立方氧化锆的吸收光谱特征表明它是Nd致色. 能谱分析结果表明: 彩色立方氧化锆的常见元素有Zr, Y, P, Hf, Ca等; Er, Ce, Fe分别是粉红色、红色、酒黄色立方氧化锆的致色元素; 当Y2O3的摩尔分数大于或近于7%时, 立方氧化锆为立方面心结构且内部洁净; 当Y2O3的摩尔分数小于5%时, 立方氧化锆表现为非均质性且内含大量定向分布的白色脱溶物. 用拉尔森改写的格拉斯顿-代尔公式计算其近似折射率为2.12～2.19.